1A. Support Bracket
Support Brackets are installed to the eave’s fascia board. If the fascia board is larger than the gutter system then flashing trims such as our J-Covers should be installed prior to bracket installation. Support brackets are fastened with #10 x 2" wood screws.

1B. Keeper Bracket
Keeper Brackets are provided for the Roman Fascia Profile due to its large size (keeper brackets are not necessary for our other profiles).

2. Concealed Liner
Aluminum gutter liners are factory notched to receive both support brackets and interior straps. Notching for these brackets alternates for equal offset spacing. Liners are manufactured with 1" telescoping joints which are field riveted and sealed with a high performance gutter seal or clear silicone caulk. Once the liner is mounted onto its mating support brackets, its upper rear edge is fastened through factory elongated holes.

3. Snap-On Fascia
Fascia selection must be determined when ordering the Designer Series Gutter System. Each fascia profile has its own unique support bracket and for this reason fascia profiles are not interchangeable. Fascias are installed by hooking their lower hemmed edge over the support bracket’s lower retainer stem and pulling into position. Fascia joint treatment is a 3/8" expansion reveal with a 6" concealed (backup) splice plate.

4. Interior Strap
Interior straps complete the system installation. These straps weave through notched holes in the liner’s outer lip, engaging the fascia’s hemmed edge, and are riveted to the liner’s upper rear edge. Once installed, the straps securely lock the decorative fascias in place.