SAF Designation System for aluminum finishing, including SAFinish coatings

SAF Anodizing Guide Specification Form

CUSTOM PAINTING & ANODIZING

• Anodizing
• Spray Coatings

ANODIC FINISHING ON EXPOSED ALUMINUM COMPONENTS

(** denotes choice, see below chart to fill in the blanks.)

1. Type: All exposed aluminum shall be given caustic etch followed by an Architectural Class **(I or II)** anodic coating with color conforming to Aluminum Association Designation ___**____. The color shall be _____**______ and shall meet standards set forth by AAMA 611.
2. Designation: Southern Aluminum Finishing Co., Inc., SAFINISH “SAF____”. (e.g. SAF 215 is Class I Clear)
3. Appearance: coating shall be continuous, uniform in appearance, and free from scratches and other blemishes.
4. Color variation: No more than 5E (CMC) when measured in accordance with AATCC 173-1989.

NOTES:

1. SAFINISH coatings are recommended for long-term exterior use. Ask about our 5 and 20 year limited warranties for SAFINISH coatings.
2. Limitations: Class II dyed finishes (SAF 804) are not exterior lightfast.
3. Spectrocolorimeter conditions: integrating sphere specular included, 10 degree standard observer, D-65 Illuminant, CMC Ratio 1.50:1.00.

SAF SPRAY PAINTED SAFINISH SPECIFICATION – SPRAY PAINTED FINISHING

1. All aluminum sheet shall be finished in accordance with the designations and proprietary identification set for in the schedule on the shop drawings.
2. All high performance organic spray coatings shall meet AAMA 2605 requirements. Aluminum is to be cleaned with solutions to remove organic and inorganic surface soils, remove residual oxides, followed by a chrome phosphate conversion coating to which organic coatings will firmly adhere. Approved applicator shall apply an organic spray coating as specified below.
   1. Southern Aluminum Finishing Co shall apply a standard multicoat thermo-cured 70% Polyvinylidene Fluoride (PVDF) coating, composed of a primer specially formulated for aluminum and fluorocarbon topcoats complying with AAMA 2605.
   2. Provide color as selected by the Architect from standard choices available from Southern Aluminum Finishing Co.
3. Touch-up painted shall only be used for small scratches and abrasions and is never to be spray applied.
4. When all the metal is spray coated during the same set-up, the finish shall not show a color variation greater than 2E (CMC) when measured in accordance with AATCC 173-1989.

Aluminum Finishing NOTES:

1. SAFINISH coatings are recommended for long-term exterior use. Ask about our 5 and 20 year limited warranties for SAFINISH coatings.
2. Limitations: Class II dyed finishes (SAF 804) are not exterior lightfast.
3. Spectrocolorimeter conditions: integrating sphere specular included, 10 degree standard observer, D-65 Illuminant, CMC Ratio 1.50:1.00.